Forum questions and answers

Not all panel thicknesses in wizard are show on screen?

Wow, 60 different panel thicknesses is a lot. I see panel thicknesses from 1 to 60 mm are stored, and only 20 to 40 or so are visible on the screen. Just add a ScrollPane? Or multiple columns? What do you think is the best solution that works for you?

Edgeband on double internal wall not consistent?

Indeed. One panel does get special marked edgeband, but the other panel gets the default edgeband. This may not happen en will be resolved.

Can I place my legs standard as a function of the cabinet (as opposed to a function of the bottom panel)?

At this moment legs are always positioned relative to the bottom. This means that legs can not be positioned under the side walls and the exact position depends on the construction. Preferable, the user should be able to choose legs and Ivenza must places the legs at the 'right' location. At eg. fixed locations relative to the corners, under walls, etc .. We will put this on the feature request list.

POV-Ray scenes and rendered images send over instead of NFS share?

When using an NFS share, all kinds of race conditions may occur, especially when web application and renderer application run on different VMs.

How to avoid collisions between shelf connector and drawer runner?

Drawer runners overlap with shelf connectors when the drawer is located directly above the shelf. This may be solved by setting the Blum and Grass-drawer systems 'extra height' parameter at 1 to 2 mm.

Error messages on collisions with connectors are 'by design' only given when you run the button 'Production simulation' inside the appropriate configurator.

Please also collision detection and avoidance behavior for suspension systems?

It is possible to add a suspension system on both sides of an partitioning wall on the back wall. The holes for hardware for this are drilled in the partition. In the case of, for example, an Indaux Traser 6 is the hole (and the hardware itself) deeper than half the sheet thickness (from 18 mm sheets). In order to be able to place the hardware without conflicts, one of suspension parts must be shifted, as is the case with connectors. Noted and we pick it up.

2D / 3D View is reset in configurator at the opening of a cabinet (by double-click)

This is because the double-click, for opening a design, is also handled by the camera control.

Door hinge potentially overlaps with position of a flexible shelf?

You're right. We can see that the mounting plate of the hinge makes a collision with one of the holes of the free shelf. We are going to refine the collision detection for this scenario.